S-Series Enterprise Quick Start
S-Series Enterprise Quick Start
+1.317.845.5710
+44.1438.310163
USA (Corporate Headquarters)
Europe/Middle East/Asia
+1.317.845.5710
+44.1438.310163
USA (Corporate Headquarters)
Europe/Middle East/Asia
©2013 ExacqTechnologies #500-00043
1 Hardware Overview and Installation
4U S-Series Enterprise System
2U S-Series Enterprise System
NOTE: A power switch, additional USB ports, and a status display are also located on the front panel of the S-Series Enterprise system.
NOTE: S-series servers are configured for NIC bonding using active backup. Connect the data NIC ports (black) to Ethernet switches. The red NIC
should NOT be used to transmit data. For maximum throughput, configure the network switches for IEEE 802.3ad Link Aggregation, and enable
jumbo frames. Contact Exacq technical support for S-series configuration instructions. Failure to properly configure the S-series and network switch
might cause network failure.
100-240VAC 50/60Hz (connect 1a and 1b to separate power circuits)
Dual on-board NICs: 2a is for management; 2b is for data. Additional data NICs: 2c and 2d (optional)
Keyboard, mouse, USB memory device, or DVD burner (additional yellow USB ports for charging devices)
DisplayPort (4a), DVI-I (4b), DVI-D (4c); a maximum of two video outputs should be used simultaneously
Kommentare zu diesen Handbüchern